POLYMER
INNOVATIONS
2426 Cades Way
Vista, California 92081 U.S.A

Phone (760) 598-0500
Fax (760) 727-3127
Info@PolymerInnovations.com


Home 
| Introduction | Products | Services | Facilities | Feedback | Contact Us | Sample Analyses  
| WB4101 Presentation (Password Request) | Water Based vs Solvent Based Performance (4.4mb Powerpoint) |


MATERIAL SAFETY DATA SHEET (MSDS)
FOR
WB4101
BINDER CONCENTRATE

 
SECTION 1: PRODUCT IDENTIFICATION
Product Name: WB4101 Binder Concentrate
Issue or revision date: 1/23/02
Chemical Family: Water based acrylic
SECTION 2: HAZARDOUS INGREDIENTS
Component CAS# Quantity Threshold level Carcinogen
Ammonium hydroxide
(28% aqueous)
1336-21-6 < 5% TWA 25* ppm ACGIH
STEL 35* ppm OSHA
no listing
Acrylic polymers not required >10% not established no listing
Water 7732-18-5 >50% not established no listing
* As ammonia
SECTION 3: HEALTH HAZARD DATA
Summary of Acute Hazards: May cause eye and skin irritation.
Primary Routes of Exposure: Eye and skin contact.
Summary of Chronic Hazards: No appropriate human or animal data are available on the chronic health effects from prolonged or repeated exposure to this material.
SECTION 4: FIRST AID MEASURES
Inhalation: If overcome by exposure to vapors, remove victim to fresh air and obtain medical attention if breathing difficulty persists beyond 15 minutes.
Eye Contact: Immediately rinse with clean water for 20 - 30 minutes. Obtain emergency medical attention if pain or redness persists.
Skin Contact: Remove contaminated clothing as needed and wash skin thoroughly with mild soap and water.
Ingestion: Immediately drink 1- 2 glasses of water or milk.
SECTION 5: PHYSICAL DATA
Appearance: Viscous white hazy liquid Odor: mild ammonia like
Boiling Point: 212 ° F or 100 ° C (water) Specific Gravity: 1.0 - 1.1
Vapor Pressure: 17 mm HG @20 ° C (water) Vapor Density (air=1): Not available
Solubility in water: Dispersible pH: ~7
Percent Volatiles: greater than 50% Theoretical VOC: Less than 10 g/l
Freezing Point: Not available
SECTION 6: FIRE AND EXPLOSION HAZARD DATA
Flash Point: Noncombustible Auto-ignition Temperature: Not applicable
Lower Explosive limit: Not applicable Upper Explosive limit: Not applicable
Fire and Explosion Hazards: Dried product may burn.
Extinguishing Media: Dry chemical, CO2, water fog, water spray.
Special Fire Fighting Procedures: No special requirements.
SECTION 7: HANDLING AND STORAGE PRECAUTIONS
General: Use good personal hygiene practices. Wash hands with soap and water before eating, drinking, smoking, or using toilet facilities. Promptly remove soiled clothing and wash thoroughly before reuse.
Respiratory: No special requirements under normal use conditions. At higher concentrated levels a NIOSH or MSHA approved respirator should be used with ammonia/methylamine cartridge and dust filter.
Eye: Safety glasses with side shields or chemical splash goggles.
Skin: No special requirements under normal use conditions. If prolonged or repeated contact is possible: any impervious material.
Storage: Avoid temperature extremes. 34 ° F (1 ° C) to 120 ° F (49 ° C) recommended minimum and maximum storage temperatures. Product is however freeze and thaw stable.
SECTION 8: REACTIVITY DATA
Hazardous Polymerization: Not expected to occur
Hazardous Decomposition products: May generate CO, CO2, H2O, and acrylic monomers during thermal decomposition.
Materials to avoid: Materials not compatible with water and substances not compatible with ordinary organics such as strong oxidizers will not be compatible with this product
Conditions to avoid: Avoid temperature extremes as noted under storage.
SECTION 9: SPILL AND DISPOSAL INFORMATION
Spill: Contains ammonia. Do not let spilled or leaking material enter watercourse. May be toxic to aquatic life. Sweep or scrape up and containerize.
Disposal: Dispose of waste in accordance with all applicable Federal/ Provincial / State and local regulations regarding disposal.
SECTION 10: TRANSPORTATION INFORMATION
DOT Hazardous Material Proper Shipping Name: Not regulated.
SECTION 11:HAZARD RATING AND LABELING INFORMATION
NFPA: Health = 1 Flammability = 0 Reactivity = 0
HMIS: Health = 1 Flammability = 0 Reactivity = 0
SECTION 12: REGULATORY INFORMATION
Toxic Substance Control Act (TSCA): All ingredients are listed or excluded by TSCA.
Superfund Amendments and Reauthorization Act of 1988 (SARA): Does not contain significant quantities of any materials subject to reporting requirements.
Comprehensive Environmental Response, Compensation and Liability Act (CERCLA): Does not contain significant amounts of materials subject to reporting requirements.
SECTION 13: GENERAL COMMENTS
Abbreviations:
NISH: National Institute for Occupational Safety and Health
NFPA: National Fire Protection Association
MSHA: Mine Safety and Health Administration
TSCA: U. S. Toxic Substances Control Act chemical substance inventory
HMIS: Hazardous Material Information System (National Paint and Coatings Association).

The information contained herein relates only to the specific material identified. Polymer Innovations Inc., believes that such information is accurate and reliable as of the date of this material safety data sheet, but no representation, guarantee or warranty expressed or implied, is made as to the accuracy, reliability, or completeness of the information. Polymer Innovations Inc., urges persons receiving this information to make their own determination as to the information’s suitability and completeness for their particular application.